How to Run 1 Station on ICore

Now I'm going to show you how to manually run one station on your Hunter ICore irrigation controller. So this does not affect your normal programming. Let's just say there's one zone, it's really dry, and you wanted to run right now. This how you do that, we're going to go two to the left where it says manual operation. You have three options here - the middle one is manual station. Use the down arrow, get that arrow next manual station, plus key to choose that.Then, from here, I can use the right or left arrow and pick the zone, let’s say we want to run zone 5. Notice that the time is flashing. I could use the plus and minus key to add or subtract minutes. Let's say we want to run this zone for 15 minutes, but again, this does not change any of their normal programming. This is just for this one singular time. Now to turn it on, turn the dial back to run and it's on. You also notice that this light station light comes on letting you know that zone is on. Now there's two ways to go about it from here. We could either leave the dial and run, and after the 15 minutes it will go back to the normal programming. Or let's say after five minutes or seven minutes, whatever that you realize that it's got enough water and it doesn't need to finish out. So what you need to do if you want to turn that off, go to system off, wait for that off to get done flashing. We also see that light came off. Then you know the zone is off, and then he would just turn the dial back to run.